Accurate measurements are essential to ensure that you receive the correct fit and the right price quote. Only use a hard-edged ruler or steel tape. For measuring inside mounts, width measurements should be rounded down to the nearest 1/8" to prevent the blinds from binding against the window casing.
- For width, measure across the window casing from one inside edge to the other in three places - top, middle and bottom. Record the smallest width rounded down to the nearest 1/8".
- For length, measure the inside area from the top inside edge down to the top of the sill in three places - left, middle and right. Record the longest length rounded up to the nearest 1/8".
- The factory will make all necessary deductions for inside mount.
- Minimum Depth of Mounting Surface Required.......1 1/8"
- Minimum Depth Required for Flush Mount...............3"
- For the width, measure from one edge of the casing to the other, and then add a minimum of 4" (2" on each side) for blind overlap. Record the measurement rounded up to the nearest 1/8".
- For length, measure from the top of the window sill up to the desired top of the blind; again, record the measurement rounded up to the nearest 1/8".
- Outside mounted aluminum blinds are fabricated to your order dimensions.
- Minimum Mounting Surface Required.......2 1/4" x 1"
- Minimum Mounting Surface Required when using an Extension Bracket.........1 1/8" x 1 5/16"
- It is also possible to provide customers with cut-out blinds, which take a window air conditioner or other obstruction into consideration. The cut-out can either be from one of the bottom corners, or from the bottom middle of the blind. While a template is not required, when ordering cut-out blinds, it is required to include a detailed picture of the blind with all dimensions clearly labeled.
The 3 ¼" Crown Valance is standard on all Faux Wood blinds, and a 3 ½" Decorative Valance on all Timber Lux™ blinds at no additional charge.
- Add 1 ½" to the ordered size for all Valance options.
- The factory measures the face of the valance for width. All returns are measured from the face of the valance front to the back. The Standard Return is 2 ¾"
Our Faux Wood Blinds include at no charge a 3 ¼" Crown Valance, shown here as an outside mount with standard returns.
Our Timber Lux™ Blinds include at no charge a 3 ½" Decorative Valance, shown here as an outside mount with standard returns.
Install your valance using the above hidden valance clip.